Ford Mustang Mach 1 – Priming the Sheet Metal

Jeff sent me a few photos of the most recent transition of his 1970 Ford Mustang Mach 1. I have been a very bad brother and haven’t posted them. I blame my selfish greed for this. I will try to do better in the future.

Ok, so here they are…

July 21-22
Here are photos of the right floor firewall extension (where the passenger’s feet go).

This photo is the damage as it looked before cutting anything away.

This one is cutting the inner skin off.

The third is the sheet metal patch that was cut out to fit the hole from a replacement part.

Photo four is after the welding and grinding was done.

The fifth photo is the left floor pan seat riser installed and ready for priming and seam sealer.

August 3

Rear interior of car in primer.

Aug 8

Outside of car ready for primer.