Installing a St. Croix Prescott EXL Pellet Stove
Tuesday, August 26th, 2008|
|
Well, the guys came over yesterday to install the new St. Croix Prescott EXL pellet stove. As you might recall, our previous pellet stove was a Harman P38. I was a little nervous about switching brands because I had gotten used to Harman. Also, Harman has very good reviews. The reason I couldn’t get a Harman this time is because they are all backed up and we may not have even gotten one this season.
It took the installers about 3 hours to finish the installation. When everything was in, they fired it up to make sure everything was working properly. One of the installers noticed one issue…the auger wasn’t turning, so no pellets were falling into the burn pot. the auger motor was working fine, just not the auger itself. We made an appointment for the service guy to come out today. By the way, I could have fixed this. It was easy. I actually was almost done fixing it when the doorbell rang. That’s me beating my chest.
Today, the repair guy came out and fixed the auger issue. The small set screw on the auger shaft wasn’t tightened properly, so it wasn’t catching on the auger motor.
I must say, this unit is very nice. It has auto-light, which was very important. I am going to hook up a thermostat, so the pellet stove can shut down and start up on its own. Also, the auger and fan is much quieter than the Harman. The whole system just seems to be more elegant. For a few hundred bucks more, I am happy that I went with this model.
Here are some photos…
St. Croix Prescott EXL pellet stove
St. Croix Prescott EXL pellet stove control panel
St. Croix Prescott EXL pellet stove inside venting
St. Croix Prescott EXL pellet stove outside venting
What’s nice is that the outside venting is under the porch. The necessary clearances are 24″ away from the porch and 12″ off the ground. Also, since we used the fresh air kit, the clearances from windows and doors is only 9″. I would say that’s one of the huge benefits of pellet stoves.
